FAQ

Troubleshooting Copy Trade Failures

If the copied wallet opens and closes positions too frequently (for example, opening and closing within one minute), copy trades may fail.

When you encounter a copy trade failure, please refer to the error codes below or contact an admin for further assistance.

Error Code	Meaning
-1	Unknown error
-1001	Insufficient balance
-1002	Invalid trade amount
-1003	Invalid follower wallet amount
-1004	Copy amount too small — size × leverage must be greater than 10 USDC
-1005	Failed to retrieve token information
-2001	Failed to retrieve your wallet account
-2002	Failed to retrieve copied wallet account
-2003	Token order not found in copied wallet
-2004	Incorrect balance in copied wallet
-2005	No position found in your wallet
-2006	Failed to create order — please contact the admin group for details
-2007	Failed to retrieve metaAndAssetCtxs interface

---

Why does my remaining balance differ from the leader’s proportion when using proportional copy trading?

This happens because when calculating the opening margin, the system uses the larger value between:

1. The proportional margin based on your copy ratio, and

2. Your minimum order size setting.

This ensures each copy trade executes successfully (since Hyperliquid requires margin × leverage > 10).

Your funds may deplete faster if:

• There’s a large gap between your balance and the wallet your copying (e.g., Copied wallet has $1 M while you have $100), or

• The copied wallet trades too frequently — if the calculated position size is below 10, the system will use your minimum order size instead, increasing fund usage.

Tips to optimize:

• Follow wallets that don’t open or add positions too frequently, or

• Lower your minimum order size from 5 to 2 to reduce capital usage speed.

---

What are the copy trading fees?

• Default fee: 0.055%

• With referral code: 5% discount → 0.052%

• With membership: as low as 0.035%

• Membership + referral code: only 0.033% (~40% off)

---

What’s the execution delay for copy trades?

The current measured delay is about 5 seconds, making it one of the fastest in the industry.

This delay exists because Hyperliquid’s copy trading logic must:

• Aggregate and deduplicate trade fills, and

• Continuously query wallet data to ensure accurate proportional replication.

These processes ensure precision and safety. Reducing this delay further could cause duplicate orders or missed signals.

⚠️ Note: Be cautious of platforms claiming “millisecond-level” copy trading — given current on-chain and Hyperliquid architecture, this is technically impossible.